King Gee hi-vis combination overall, spliced

The K51525 is a one piece hi-vis combination overall from King Gee, built for crews who want full coverage in a single garment. It pulls on over your clothes or your work gear and closes up the front, so you cover legs and torso in one go rather than pairing a shirt and trousers.

The "spliced" part refers to the two tone hi-vis build, with a contrast lower section and reflective tape across the back. The front does up with a fly and nickel press studs, and there is a sensible spread of pockets for the tools and pens you actually carry on a shift.

If you work in a yard, depot or site where you want a tidy, visible layer that goes on quickly, this overall is worth a look. You can see the full listing and current sizing on the King Gee overall product page at Done Right Safety.

Picking the right overall for the job

Start with how visible you need to be and how the overall will sit over what you already wear. A combination overall like this covers torso and legs in one piece, so think about whether you will wear it over a base layer in cooler months or straight over light clothing when it warms up. Check the sizing on the product page and allow a little room if you plan to layer underneath.

The pockets matter more than people expect. The K51525 has two chest pockets, a pen partition on the left, a back patch pocket and a tool pocket inside the seam, so map those against what you carry daily. If pens, a phone and a few small tools live on you all shift, that layout earns its keep.

Checking the fit and closure

Before a full day in it, do up the fly front and nickel press studs and run through a normal range of movement: squat, reach overhead, climb a step. You want the overall to move with you rather than pull tight across the shoulders or seat. If the studs gape or the legs ride up, size up.

Looking after it

Follow the care guidance on the product page, since wash settings affect how the reflective tape and press studs hold up over time. Keep the 50mm hoop tape clean so it stays visible, and check the studs and seams now and then. Standards, ratings and any hi-vis certification should be confirmed on the product page or datasheet rather than assumed, as the listing here does not state a specific standard.

The Bisley, Hard Yakka and DNC in the table are the same type of one piece overalls and coveralls from Done Right Safety, so the comparison is like for like. The differences come down to fabric, pocket layout, ventilation and whether a hi-vis standard is listed.

If the listed hi-vis tape and a pen plus tool layout are your priorities, the King Gee is the straightforward pick, since it spells out the 50mm Reflectec hoop tape and the inside seam tool pocket. Go to the Bisley if you want a phone pocket and the extra back movement of an action back, or the Hard Yakka if having a stated certification on the listing matters to you.

The DNC sits slightly apart: it leans on underarm cotton mesh vents for warmer days, but its listing here gives fewer pocket details, so confirm those on its product page before you commit.

What the listing confirms is solid and practical. You get a two tone hi-vis combination overall with a fly front and nickel press studs, two chest pockets, a left side pen partition, a back patch pocket with 50mm Reflectec hoop tape and a tool pocket inside the seam. That is a sensible working layout for a single piece garment.

What the listing does not state is the fabric weight, the colour options, the size range or any hi-vis standard. None of those are claimed here, so treat them as items to verify rather than assume. If meeting a specific hi-vis standard is a site requirement for you, confirm it on the product page or datasheet first.

For buyers who want a tidy, visible overall that goes on quickly and carries the everyday bits, this King Gee is an easy one to shortlist. Just line up the sizing and any certification needs against the product page before you order.